VERY IMPORTANT
In order to validate your warranty it is essential that you register it. Warranties must
be registered online
Please register your warranty by visiting
www.powershield.com.au
1. Introduction
Thank you for purchasing Defender 1200/1600. It is designed to provide safe and
reliable power protection to your precious electronics equipment.
Before you start using the product, please read this user’s manual. It contains
instructions relating to safety, installation, operation maintenance and warranty.
Please keep this manual in a safe place for future use.
2. Safety instruction
Please read following safety instruction carefully before using Defender 1200/1600
ATTENTION ! : ELECTRICAL SAFETY.
To prevent the risk of fire and electric shock, install the product in a controlled
temperature and humidity indoor area where it is free from conductive
contaminants.
To reduce the risk of overheating of the product, do not cover the cooling vent
holes and avoid exposing the unit under direct sunlight or installing the unit near
the heat emitting appliances such as heaters or furnaces.
Do not connect non computer related equipment such as medical equipment,
life-support system, microwave oven, vaccum cleaners. Also since this unit
output is not sinusoidal, please do not connect AC line filters, motors and other
inductive / capacitive equipment. These equipment might damage the unit.
Do not plug the unit input cord to its own output.
Do not allow liquids or any foreign object to get inside the unit. Do not place any
liquid formed materials on the top of the unit or right next to it.
For safety purpose, proper grounding is necessary during installation of the unit
in order to reduce the leakage current below 3.5mA.
Hazardous due to electric shock. Although, unit is disconnected from the mains,
hazardous voltage may still be accessible through supply from the battery.
Battery connection should be disconnected when servicing the product.
To Next Page
General
