Manual#: 851-000134
Version 3.4 – 08/11/2022
5.3 List of Email Commands
This forces the PQube 3 to send a sample email.
Your new setup file name must start with “Setup” and have the “.ini”
filename extension (e.g. Setup.ini or Setupxxx.ini), and must be
attached to the email.
Your PQube 3 will send you two reply emails: One when it receives the
new setup file, and another when the new setup file has been
successfully installed.
Resets PQube 3 upon receipt of email. This is useful when loading a
new setup file or firmware via FTP.
You can ask your PQube 3 to send you its log files via email. The log
files can help diagnose PQube setup problems, and they show the
complete history of your PQube.
For faster technical support, please include these files when
contacting our technical support department.
Retrieve the existing setup file from your PQube 3.
Takes a waveform recording of your power.
Generates the Daily Trends for today. The data ranges from midnight
to the moment the email request is received.
Note: You can test emails using the PQube 3 screen. You can also send an email remotely from the PQube 3
Command Page by pressing the email test command.
To Next Page
Loading...
Need help?
General
