English
Important Safety Instructions
CAUTION
RISK OF ELECTRIC
SHOCK DO NOT OPEN
The Lighting Flash with Arrowhead symbol within an
equilateral triangle, is intended to alert the user to
the presence of uninsulated “dangerous voltages”
within the product enclosure that may be of sufcient
magnitude to constitute a risk of shock to persons.
The Exclamation point within an equilateral triangle,
is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the
product.
EXPLANATIONS OF GRAPHICAL SYMBOLS
The CE-mark indicates the compliance with the
low voltage and electromagnetic compatibility.
Symbol for earth/ground connection.
Symbol indicating that the equipment is for indoor
use only.
Symbol for conformity with Directive 2012/19/EC
of the European Parliament on waste electrical and
electronic equipment (WEEE).
Do not use the unit at altitudes above 2000 m.
Do not use the unit in tropical environment.
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT ATTEMPT TO OPEN ANY PART OF THE UNIT. NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
CONNECTION TO THE MAINS SHALL BE DONE ONLY BY A
ELECTROTECHNICAL SKILLED PERSON ACCORDING THE
NATIONAL REQUIREMENTS OF THE COUNTRIES WHERE THE
UNIT IS SOLD.
USE ONLY BATTERIES, CHARGERS, AND OTHER ACCESSORIES
APPROVED BY POWERSOFT FOR USE WITH THIS DEVICE.
PLEASE REALIZE THAT BATTERIES MIGHT CAUSE DAMAGES
LIKE LEAKING, FIRE OR EXPLODE WHEN MISUSE OR DEFECTIVE.
NEVER MAKE WRONG POLARITY CONNECTION WHEN
CHARGING AND DISCHARGING BATTERY PACKS. ALWAYS
DOUBLE CHECK POLARITY OF BATTERY’S CONNECTOR TO
MAKE SURE RED WIRE TO RED WIRE AND BLACK WIRE TO
BLACK WIRE.
FOR SAFETY REASON, WE USUALLY SHIP BATTERY NOT FULLY
CHARGED: YOU MUST CHARGE THE BATTERY BEFORE USE.
BATTERIES (BATTERY PACK OR BATTERIES INSTALLED) SHALL
NOT BE EXPOSED TO EXCESSIVE HEAT SUCH AS SUNSHINE,
FIRE OR THE LIKE.
WARNING TO PREVENT INJURY, THIS APPARATUS MUST BE
SECURELY ATTACHED TO THE FLOOR/WALL IN ACCORDANCE
WITH THE INSTALLATION INSTRUCTIONS.
Electrical energy can perform many useful functions.
This unit has been engineered and manufactured to ensure
your personal safety. But IMPROPER USE CAN RESULT IN
POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARD.
In order not to defeat the safeguards incorporated into this
product, observe the following basic rules for its installation,
use and service. Please read these “Important Safeguards”
carefully before use.
Important safety instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this equipment near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
ampliers) that produce heat.
9. Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding-type plug
has two blades and a third grounding prong. The wide
blade or the third prong are provided for your safety. If
the provided plug does not t into your outlet, consult
an electrician for replacement of the obsolete outlet.
10. Protect the power cord from being walked on or
pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11. Only use attachments/accessories specied by the
manufacturer.
12. Use only with the cart, stand, tripod,
bracket, or table specied by the
manufacturer, or sold with the apparatus.
When a cart is used, use caution when
moving the cart/apparatus combination
to avoid injury from tip-over.
13. Unplug this apparatus during lightning storms or when
unused for long periods of time.
14. Refer all servicing to qualied service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has
been exposed to rain or moisture, does not operate
normally, or has been dropped.
15. The apparatus shall be connected to a MAINS socket
outlet with a protective earthing connection
16. Where the MAINS plug or an appropriate coupler is
used as the disconnect device, the disconnect device
shall remain readily operable.
To Next Page
Loading...
Need help?
General
