PowerSpec Pro 3D Printer - 1 Whats Included in the Box; 2 Un-Boxing

２
1 What's Included in the Box?
Along with your 3D printer, the box also contains the following:
In the two long boxes on the top of the package, you’ll find:
 Power cord x 1pc,
 USB A to B cable x 1pc,
 Sensor Line x 1pc,
 Filament guide tube x 2 pcs.
 Filament spool holder x 2 pcs.
An accessory box on the top of the 3D Printer:
 Dual extruder heads x 1pc,
 4G SD card x 1 pc,
 Bolt, hex wrench and screws kit x 1 bag.
2 Un-boxing
The 3D Printer was carefully packaged at manufacturing facility. Please follow the unboxing steps laid out below.

First, put the box on the floor in a clean and flat surface. Remove the top EPE foam piece and put the two long boxes
aside. You will find 1x power cord, 1x USB A to B cable, 2x filament guide tubes, and 2x spool holders in these two
long boxes.
CAUTION
Handle the package and its contents with extra care; do not use any unnecessary force.
Do not remove the thin yellow film from the heating plate. It is heat resistant tape that improves the
adhesion of the extruded plastic to the plate.
Do not remove the wrapping around the nozzle. It consists of a ceramic fiber fabric and heat resistant
tape that helps to keep the nozzle at a constant temperature.