PowerTec PT2200i - Engine Oil Replacement

22.
23.
www.powertec.net.nz
www.powertec.net.nz
PT2000i DIGITAL INVERTER GENERATOR
Engine Oil Replacement
Initial replacement of the engine oil is after one month
or 20 hours of operation.
1. Place the generator on a level surface and warm
up the engine for several minutes. Then stop the
engine and turn the Fuel Tap knob to “OFF” and the
Fuel Tank Cap Air Vent knob to “OFF”.
2. (A) Remove the screws (1) and then remove the
cover (2).
3. Remove the oil ller cap.
4. Place an oil pan under the engine. Tilt the generator
to drain the oil completely.
5. Return the generator to a level surface.
CAUTION!
DO NOT tilt the generator when adding engine
oil. This could result in overlling and damage to
the engine.
6. (B) Add engine oil to the upper level as seen in the
diagram (1).
Recommended engine oil:
• SAE10W-30
Recommended engine oil grade:
API Service SE type or higher
Engine oil quantity:
0.4 Litre
7. Install oil ller cap, cover, and screws.
B.
C.
D.
E.
A.
2
1