6
OPERATION DETAILS
1. Plug the cable connector into the car jump starter
• Red Light On
- The voltage of jump starter cannot support to start
- Check voltage of Jump Starter
• Red and Green Light Flash
- Please check the voltage of jump starter belong to 12V/16V
- Go to Step (2)
2. Connect the jump starter to the car battery
• Red Light on and Buzzer
- Short Circuit
- Disconnect the jump starter and car battery, go back to step 1.
• Red Light on and Buzzer
- Reverse Polarity
- Disconnect the jump starter and car battery, go back to step 1.
• Red and Green light flash within 1-35 and then the Green Light on
- Working Status
- Turn on the Key
3. Green Light On
• Red Light Flashes
- Cannot start within 30S
- If you need to repeat use, disconnect and reconnect the connector
To Next Page
Loading...
