14
ADVANCED (ADV.) AGM MODE (15V 7.5A):
SMPS 13.6V MODE (13.6V 5A):
This mode is mainly suitable for charging 12V lead-acid batteries with a
capacity greater than 18 Ah. It can be used to the maximum charge voltage
15V of the special AGM battery such as calcium battery; however battery
manufacturers may recommend the maximum charge voltage for charging
their batteries. Please check battery specifications.
Press the MODE selection button to select MODE ADVANCED AGM 12V.
After doing so, the corresponding LCD display ADVANCED AGM 12V lights up.
Then if you do not take any further action, the electronic system will
automatically start the charging process together with the LCD display will
flash at (with a current of) 7.5A. If the process runs without any problems, the
LCD display will show the battery charging (bars will start flashing) until the
battery is charged. When the battery is fully charged, the battery icon should
be full and will stop flashing. The device now switches automatically into
maintenance charging mode.
This mode is adaptor, it can be used to as a 13.6V 5.0A DC power supply, and
it can be used to float charging for 12V battery also.
Long press 3sec. the MODE selection button at no battery connected status
after doing so, the corresponding LCD display SMPS 13.6V lights up.
Then if you do not take any further action, the electronic system will
automatically start the power supply output process as adaptor function
together with the LCD display the output is 13.6V DC 5.0A.
NOTE: DO NOT short-circuit the output terminals after the MODE SMPS
13.6V has started.
To Next Page
Loading...
Need help?
General
