10
MEMORY FUNCTION / RESET:
SWITCHING BETWEEN MODES:
After connection to mains, the charger automatically returns to the last
charge mode used. If the charger stays on “STANDBY” press the mode key.
NOTE: Long press 3sec. the MODE selection button at no battery connected
status. The device switches between charging modes in the following order:
Standby > MODE 6 SMPS 13.6V > then repeats the cycle.
Press the MODE selection button the appropriate number of times.
The device switches between charging modes in the following order for
12V battery:
Standby > MODE 2 > MODE 2 & 3 and > then
repeats the cycle.
The device switches between charging modes in the following order for 24V
battery:
Standby > MODE 1 > MODE 1 & 3 and > then
repeats the cycle.
Long press 3 sec. the MODE selection button the appropriate number of
times. The device switches between charging modes in the following order:
Standby > MODE 4 AGM + 12V > MODE 9 AGM + 16V (RACING) >
MODE 5 RECOVER 12V > MODE 7 LITHIUM 12.8V > MODE 10
LITHIUM + 16V (RACING) > MODE 5 RECOVER 12V >
then repeats the cycle.
NOTE:
• MODE 7 LITHIUM 12.8V: If voltage of the battery is out of 11.6-13.8V,
Mode 7 is not available, will go to MODE 5 RECOVER 12V directly.
• MODE 5 RECOVER 12V: Repair & Recover and charging the deeply
discharged or sulfated (desulfation) 12V batteries.
• If you press the selector button, charging mode automatically switches
over to the next mode and begins operation in that mode.
To Next Page
Loading...
Need help?
General
