Powertrain V30 User Manual

11
E2
No signal from motor.
Possible Cause: Check the motor cable to see whether it is
connected well or not, if not, re-connect the motor wire again.
Check the motor cable to see whether it is damaged or has a burnt
smell, if yes, replace the motor.
E5
Current overload
protection:
Whilst in use, the lower
controller detects the current
to be over 6A for more than
3 seconds.
Possible Cause:
Overloading leads to excessive current, and the system stops out of
self-protection, or some part is stuck, causing the motor to stop.
Adjust the treadmill and restart it. Check if there is liquid or burnt
smell while the motor is running, if yes, replace the motor; check if
the controller has a burnt smell, if yes, replace the controller; check
the power supply voltage, if it does not match the specifications,
change into correct voltage and test the machine again.
E6
Explosion-proof impact
protection: the abnormal
voltage or motor cause a
circuit fault which drives the
motor.
Possible Cause:
Check if the power supply voltage is 50% lower than normal
voltage，use the correct voltage and test the machine again；check
if the controller has a burnt smell and replace the controller; Check
if the motor cable is connected and connect the motor wire again.
E7
No safety key
Put the safety key on the right place.
7. Maintenance
Warning: Before cleaning or carrying out any maintenance, ensure the treadmill is
disconnected from power
 Comprehensive cleaning will extend the life of your treadmill
 Remove dust periodically in order to maintain all parts clean.
 Be sure to clean running belt with both sides of the exposed portion, which will reduce
the accumulation of impurities.
 Make sure to wear clean athletic shoes to avoid introducing dirt on to the running board
and belt.
 Treadmill belts must be cleaned with a damp cloth with a mild soap.
 Ensure none of the components and the treadmill itself come into contact with liquids
which will void all warranty.
Warning: Make sure power plug disconnect before moving motor cover away, clean
the motor at least once a year.
Maintenance of the Running Board and Belt - Lubrication and Cooling
 Your treadmill's running board and running belt had been lubricated at the factory.
 Friction between the running belt and running board has a great impact on the life and
performance of your treadmill.
 Regular application of treadmill lubricant is needed. We advise you to check the board

Powertrain V30 Specifications

General

Brand	Powertrain
Model	V30
Category	Treadmill
Language	English