Important Safety Instructions
Please save these instructions for future use!
Please keep this manual for future use.
This manual contains all safety, installation and operating instructions for the POW-HPM Series all-in-one
solar charge inverter. Please read all instructions and precautions in the manual carefully before installation
and use.
Non-safety voltage exists inside the all-in-one solar charge inverter. To avoid personal injury, users shall not
disassemble the all-in-one solar charge inverter themselves. Contact our professional maintenance personnel
if there is a need for repair.
Do not place the all-in-one solar charge inverter within the reach of children.
Do not install the all-in-one solar charge inverter in harsh environments such as moist, oily, flammable or
explosive, or heavily dusty areas.
The mains input and AC output are high voltage, so please do not touch the wiring terminals.
The housing of the all-in-one solar charge inverter is hot when it is working. Do not touch it.
Do not open the terminal protective cover when the all-in-one solar charge inverter is working.
It is recommended to attach proper fuse or circuit breaker to the outside of the all-in-one solar charge inverter.
Always disconnect the fuse or circuit breaker near the terminals of PV array, mains and battery before
installing and adjusting the wiring of the all-in-one solar charge inverter.
After installation, check that all wire connections are tight to avoid heat accumulation due to poor connection,
which is dangerous.
The all-in-one solar charge inverter is off-grid. It is necessary to confirm that it is the only input device for load,
and it is forbidden to use it in parallel with other input AC power to avoid damage.
To Next Page
Need help?
General
