12780 San Fernando Road, Sylmar, California 91342 | www.semcopackaging .com | Email: semcoinfo@PPG.com
|
5
4. Safety features
4.1 There are two primary safety features on this machine: machine safety guard door and stop push
button.
4.2 The guard door is intended to prevent entry into the machine operating area while the machine is in
operation. The mixer may not stop immediately when door is opened. Therefore, caution must be taken
before opening the machine.
4.3 The stop button is located on the front of the machine. This button is to be used when an emergency
arises, and the machine needs to be stopped immediately.
5. Set-up
5.1 Make sure the mixer is placed on a firm level surface to withstand the weight of the machine. Check the
working surface area and operation area.
5.2 Prior to use, verify mixer is in good and safe operational condition. Do not operate mixer if safety
guards, operating parts, or components are damaged or missing.
5.3 Never operate mixer without a cartridge.
5.4 Never release a cartridge when the mixer is in operation.
5.5 Always place cap assembly onto its holder when mixer is not in use or between cartridge cycles.
5.6 When mixing dangerous or hazardous contents, please follow the safety precautions for handling
and processing the product specified by the manufacturer or supplier.
5.7 If necessary, the Semco 1088 CE non-twist mixer can be mounted to a flat surface using bolts and
mounting holes drilled through the base plate.
5.8 NOTE: After a long period of storage or initial use, the compressed air motor may not start immediately
when the start button is pressed. In this case, the spindle may need to be manually turned several
revolutions in a counterclockwise direction. Afterwards, press start button to begin mixing.
To Next Page
Loading...
