20
|
12780 San Fernando Road, Sylmar, California 91342 | www.semcopackaging.com | Email: semcoinfo@PPG.com
12. Troubleshooting
Issue: After closing the door and pressing ‘Start’ the mixer does not start
1. Check the air line and ensure it is ‘on’ and hooked up to the mixer properly.
2. Check the air supply switch and ensure it is in the ‘on’ position.
Air supply switch in the ‘Off’ position Air supply switch in the ‘On’ position
3. Ensure that the safety door pin is properly engaging the safety switch when the front door is closed. The
switch is circled below:
To Next Page
Loading...
