4225V100-UK 37
[49]
[50]
[51]
[52]
[53]
[54]
[55]
[56]
[57]
[58]
[59]
[60]
[61]
[62]
[63]
[64]
[65]
[66]
[67]
[68]
[69]
[70]
[71]
[72]
[73]
[74]
[75]
[76]
[77]
[78]
[79]
[80]
[81]
[83]
Select no error action - undefined relay state - at limit
error
Open relay contact at limit error
Close relay contact at limit error
Hold relay status at limit error
Set output response time [seconds]
Set output and relay power-on delay [seconds]
Enter Relay Latch setup
Select Analog Input Function
Enter Language setup
Enter Password setup
Enter Simulation mode
Perform Process calibration
Enter Display setup
Perform Memory operations
Load saved configuration into module
Save configuration in display front
Adjust LCD contrast
Adjust LCD backlight
Write a 6-character device TAG
Output value is shown in display line 3
Device TAG is shown in display line 3
Calibrate Input low to process value?
Calibrate Input high to process value?
Set value for low calibration point
Set value for high calibration point
Use process calibration values?
Enable input simulation?
Set the input simulation value
Relay simulation - use 1 and 2 to toggle relay 1 and 2
Enable password protection?
Set new password
Enable Fastset functionality?
Select language
Enable Relay Latch function?
Select no input function
Select 0.5 Hz low cut off on input. (No effect on period
time input)
Select Square Root Input Function
Relay setpoint - press 3 to save
Relay setpoint - read only
Relay is latched - press 3 to acknowledge
Relay 1 is latched - press 1 to release
Relay 2 is latched - press 2 to release
Relays are latched - press 1 or 2 to release relay 1 or 2
Enter setup menu? (Latched relays may release!)
Release relay? (if conditions allow)
Select low value of square root
Select high value of square root
Disable low cut-off
Set low cut-off type to linear
Set low cut-off type to zero
Select low cut-off point in % of input range
Select PNP open collector output
Select NPN open collector output
Select Push-Pull output
Set high-level voltage on PNP / Push-Pull output
Set input pulses per revolution
To Next Page
Loading...
Need help?
General
