16 9202 - Product Version 9202-003
CONFIGURATION /
OPERATING THE FUNCTION KEYS
Documentation for routing diagram.
In general
When configuring the 9202, you will be guided through all parameters and you
can choose the settings which fit the application. For each menu there is a
scrolling help text which is automatically shown in line 3 on the display.
Configuration is carried out by use of the 3 function keys:
1 will increase the numerical value or choose the next parameter
2will decrease the numerical value or choose the previous parameter
3will save the chosen value and proceed to the next menu
When configuration is completed, the display will return to the default state 1.0.
Pressing and holding 3 will return to the previous menu or return to the default
state (1.0) without saving the changed values or parameters.
If no key is activated for 1 minute, the display will return to the default state
(1.0) without saving the changed values or parameters.
Further explanations
Password protection: Programming access can be blocked by assigning a
password. The password is saved in the module in order to ensure a high
degree of protection against unauthorised modifications to the configuration.
Default password 2008 allows access to all configuration menus.
Cable fault information via display front 4501
Cable fault (see limits in the table) is displayed as CA.BR (cable break) or CA.SH
(cable short-circuited). Cable fault is shown independently for each channel
but the configuration is common for both channels. In case of cable fault the
backlight flashes. This can be reset by pressing the 3 key. When the cable
fault has been remedied, the module will return to normal operation.
To Next Page
Loading...
