12/23
Sensor Err S2-M1
Rotating Gobo wheel (2# drive board motor 1) error
Sensor Err S2-M2
Gobo rotation (2# drive board motor 2) error
Sensor Err S2-M3
Effect Wheel (2 drive board motor 3) error
Sensor Err S3-M1
Focus (3# drive board motor 1) error
Sensor Err S3-M2
Zoom(3# drive board motor 2) error
Sensor Err S3-M3
Prism (3# drive board motor 3) error
Sensor Err S3-M4
Prism rotation (3# drive board motor 4) error
Sensor Err S3-M5
Fixed Gobo wheel (3# drive board motor 5) error
Over Temp Error
Temp Sense Error
Head Fan 1 Fail
Head Fan 2 Fail
Head Fan 3 Fail
Head Fan 4 Fail
Pan Encoder Err
Tilt Encoder Err
Pan Enc T Out
Pan Auto-Position Overtime
Tilt Enc T Out
Tilt Auto-Position Overtime
Pan Sensor Error
Tilt Sensor Error
Pan Over Temp
Pan Driver Fault
Tilt Over Temp
Tilt Driver Fault
Pan Enc Rev Err
Pan Encoder Reverse Wiring Error
Tilt Enc Rev Err
Tilt Encoder Reverse Wiring Error
Remark:
1. In the synchronous control of multiple projectors parameters can be transmitted from the master including: DMX mode,
display setting, operation mode(user memory);
2. all projectors Accepting parameters will automatically be set to slave mode.
Signs on top-right of the menu Panel:
S: Slave Status M: Master Status
D: DMX512 Mode I: Preset Memory Mode
U: User Memory Mode T: Test Mode
If Lock logo on, all buttons locked. press ”CONFIRM” key more than 3seconds, the lock logo disappears and buttons are
unlocked
To Next Page
Loading...