PR Lighting XR 230 SPOT PR-2200 - Master;Slave Mode Operation; Synchronous Control Setup; Master;Slave Connection Diagram; Operation Menu Structure

7/23
STAND-ALONE MODE
Operate the projector without connecting a controller, enable the master mode in the operation panel, the projector will
run in Stand-Alone mode automatically.
MASTER/SLAVE MODE
Without using a controller, many projectors can run synchronously in the Master/Slave mode by linking them with each
other. Connect the controller’s output to the first fixture’s input, and connect the first fixture’s output to the second fixture’s input and
connect the rest fixtures in the same way. Eventually connect the last fixture’s output to a DMX terminator as shown in the figure below.
Then the first one is the master with setting options as master mode enabled, and others are slaves.
Start Address for all slaves is 001. The Master can run at any mode for the Master and Slaves run at the corresponding
mode compared to the Master.
After switched on, the group will run at Master/Slave Mode.
.
OPERATION MENU
First Menu Secondary Menu Third Menu Fourth Menu
DMX Address
DMX 地址
XXX
（XXX:1~449）
Reset
Are You Sure
Config Settings
DMX Mode
（Default：Standard）
Standard 16
Extended 16
Short 8
Lamp Control
（Default：CHAN）
By Control Channel
By Power On
By DMX Present
Loss of DMX
When DMX is Lost Normal Time out
INPUT
OUTPUT
MASTER
SLAVE SLAVE
INPUT
OUTPUT
INPUT
DMX TERMINATOR