PR Lighting XR 230 SPOT PR-2200 - DMX Focus, Zoom, Pan, Tilt Settings; DMX Control Functions (Lamp, Reset); Maintenance; Component Replacement Procedures

16/23
232-239
Shake of Gobo 7
240-247
Shake of Gobo 8
248-255
Shake of Gobo 9
12 13 17
Gobo Rotation
000-128
Gobo Indexing (0°-540°)
129-188
Rotation (Clockwise from slow to fast)
189-195
Stop
196-255
Reverse rotation (Anti-Clockwise from
slow to
f
ast
)
14 18
Gobo Rotation
Fine
0-255
Gobo Rotation in 16 Bit
13 15 19
Prism
000-016
White
017-255
Three-Facet Prism
14 16 20
Prism Rotation
000-128
Prism indexing (0°-540°)
129-191
Rotation(Clockwise from slow to fast)
192
Stop
193-255
Reverse rotation(Anti- Clockwise from slow
to fast)
15 17 21
Frost Filter
000-255
Linear Frost
16 18 22
Focus
000
-
255
Linear Focusing
23
Focus Fine
000
-
255
Focusing in 16 bit precision
17 19 24
Zoom
006
-
255
Linear Zooming
25
Zoom Fine
000
-
255
Linear Zooming in 16 bit precision
18 20 26
Pan
000-255
Pan(0°~540°)
21 27
Pan Fine
000-255
Pan in 16 bit precision
19 22 28
Tilt
000-255
Tilt(0°~270°)
23 29
Tilt Fine
000-255
Tilt in 16 bit precision
24 30
Pan & Tilt Speeds
000-255
Pan & Tilt Speed from fast to slow
20 25 31
Control
000-047
Reserved
048-080
Reset
081-112
Reserved
113-144
Lamp off ( delay for 3 s)
145-168
Reserved
169-200
Lamp half power
201-223
Reserved
224-255
Lamp full power
Prism is prior to Frost Filter.
MAINTENANCE
If the projector’s lens becomes damaged or broken it should be replaced. If the lamp becomes damaged or deformed in any way it must
be replaced. If the light from the lamp appears dim this would normally indicate that it is reaching the end of its life and it should be
changed at once, aged lamps run to the extremity of their life might explode. If the projector does not function, check the fuses on the
power socket of the projector, they should only be replaced by fuses of the same specification. The projector has overheat protection
device that will switch off the projector in case of overheating. Should it happen, check if the fans are blocked or not, or if they are dirty,
clean them before switching on the projector again.
Any maintenance work should only be carried out by qualified technicians.