2/23
INDEX
SAFE USAGE OF THE PROJECTOR 3
INSTALLING THE PROJECTOR 4
FITTING THE LAMP 4
POWER SUPPLY – MAINS 5
CONTROL CONNECTIONS 5
DMX TERMINATOR 6
SETUP OPTIONS-PROJECTOR CONFIGURATION 6
TO SET THE DMX START ADDRESS 6
STAND-ALONE MODE 7
MASTER/SLAVE MODES 7
OPERATION MENU
ERROR MESSAGE
7
11
REPLACING GOBOS 13
DMX PROTOCOL 13
MAINTENANCE 16
LUBRICATION 16
KEEPING THE PROJECTOR CLEAN 17
TROUBLESHOOTING 17
TECHNICAL DATA 18
ELECTRICAL DIAGRAM 21
COMPONENT ORDER CODES 22
Please note that as part of our ongoing commitment to continuous product development, specifications are subject to change without notice. Whilst
every care is taken in the preparation of this manual we reserve the right to change specifications in the course of product improvement. The
publishers cannot be held responsible for the accuracy of the information herein, or any consequence arising from them.
Every unit is tested completely and packed properly by the manufacturer. Please make sure the packing and / or the unit are in good condition before
installation and use. Should there be any damage caused by transportation, consult your dealer and do not use the unit. Any damage caused by
improper use will not be assumed by the manufacturer and / or dealer.
ACCESSORIES
These items are packed together with the projector:
To Next Page
Loading...