EasyManua.ls Logo

PRACTIXX PX-RRM-2000WI - Battery and Charger Safety Instructions; Battery and Charger Safety

PRACTIXX PX-RRM-2000WI
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
w ww.practixx .com
28
|
GB
m When the mower is turned upside down, the
mains switch must always be o󰀨. The mains
switch should be turned o󰀨 during all work on
the mower’s bottom frame, e.g. when cleaning or
replacing the blades.
Safety instructions - Battery and battery charger
m Battery and battery charger
Read the instructions before charging. Make
sure your battery charger matches your local AC
supply. Make sure that the connection between
the battery charger and the battery pack corre-
sponds to the correct models. Longer service
life and better performance can be achieved if
the battery is charged when the air temperature
is between 18 °C and 25 °C. Do not charge the
battery in air temperatures below 5 °C or above
40 °C. These instructions are important as this
can prevent serious damage to the battery.
m WARNING:
Lithium-ion batteries may explode or cause re if dis-
assembled, short-circuited or exposed to water, re
or high temperatures. Proceed with caution, do not
open the battery and do not expose it to electrical/
mechanical stress. Avoid storing the batteries in di-
rect sunlight.
Do not disassemble, open or crush the battery.
Do not short-circuit the battery. Do not store bat-
teries haphazardly in a box or drawer where they
can short-circuit each other or be short-circuited
by conductive materials.
When the battery is not in use, keep it away from
other metal objects such as paper clips, coins,
keys, nails, screws or other small metal objects
that could connect from one terminal to the oth-
er. Short-circuiting the battery terminals can cause
burns or a re.
Do not expose the battery to heat or re. Avoid
storage in direct sunlight.
Do not subject the battery to mechanical shocks.
Do not allow the liquid to come into contact with
the skin or eyes in the event of a battery leak. If
contact has been made, wash the a󰀨ected area
with plenty of water and seek medical attention.
Seek medical attention immediately if a cell of the
battery has been swallowed.
Keep the battery clean and dry.
The battery performs best when operated at nor-
mal room temperature (20 °C ± 5 °C).
When disposing of batteries, keep batteries of dif-
ferent electrochemical systems separate from
each other.
Never allow people to sit on the robot. Never lift the
robot to inspect the cutting edge or carry it during
operation. Do not place hands or feet under the ro-
bot during operation.
The product must not be operated with damaged
guards, blade plate or housing. Furthermore,
it must not be operated with damaged blades,
screws, nuts or cables. Do not connect or touch
damaged cables until they have been disconnect-
ed from the power supply.
Do not use the product if the POWER ON/OFF but-
ton and the STOP button are not working properly.
Always switch the product o󰀨 via the ON/OFF but-
ton if it is not in use. The product will only start if
the POWER ON/OFF button is switched on and
the correct PIN code is entered.
If the power cord is damaged during use, press the
“STOP” button to stop the robot and unplug the
mains cable from the socket.
Scheppach does not guarantee full compatibility
between the product and other wireless systems
such as remote controls, transmitters, in-ground
electric fencing of livestock pastures or similar.
Metal objects in the ground (e.g. reinforced con-
crete or anti-mole nets) can cause the mower to
stop. The metallic objects may cause interference
with the loop signal, which may cause the mower
to stop.
The operating and storage temperature is 550
°C. The temperature range for charging is 545
°C. If the temperature is too high, the product may
be damaged.
Never use or charge the robot in explosive and/or
ammable environments.
Do not use the robotic lawnmower if a sprinkler is
running. In this case, program the robot and the
sprinkler so that they do not operate simultaneous-
ly.
Do not wash the robot with high pressure water
jets or immerse it partially or completely in water
as it is not waterproof.
Use only the battery charger and mains power unit
provided by the manufacturer. Improper use may
result in electric shocks, overheating or leakage of
corrosive liquids from the battery.
Do not position the power supply unit at a height
where it could be submerged. Do not set the mains
power unit down on the ground.
Do not cover the power supply unit. Condensation
can damage the power supply unit and increase
the risk of electric shock.
If liquid leaks, wash the battery with water / neu-
traliser.
m In the event of eye contact, consult a doctor.

Related product manuals