w ww.practixx .com
GB
|
39
• Defective or used batteries must be recycled in ac-
cordance with Directive 2006/66/EC.
• Hand in the device and the battery charger at a
recycling centre. The plastic and metal parts used
can be separated by type and thus recycled.
• Dispose of batteries when discharged. We recom-
mend covering the poles with an adhesive strip to
protect against a short circuit. Do not open the bat-
tery.
• Dispose of batteries according to local regulations.
Return batteries to a used battery collection point
where they can be recycled in an environmental-
ly friendly manner. Ask your local waste disposal
company about this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. Dierent provisions may apply to the
disposal of electrical and electronic appliances in
countries outside the European Union.
Notes on lithium-ion batteries
Removing the battery before disposing of
the device!
• Do not dispose of the battery in household waste, in
a re (risk of explosion) or in water. Damaged bat-
teries can harm the environment and your health if
toxic vapours or liquids escape.
15. Troubleshooting / fault codes
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
15.1 Fault table
Fault Possible cause Remedy
Mower does not start
Mower or charging station not
connected to the mains.
• Connect the power supply unit to a suitable
power source.
• Call a specialist if necessary.
LED light on charging station
does not light up
LED light on charging station
ashes red
Boundary wire is not connected
or cut/broken.
• Connect/repair boundary wire.
Mower does not mow properly Blades are worn. • Replace blades.
Mower starts at unusual/
wrong times
Date/time is incorrectly set. • Set the correct date and time.
Mower gets stuck Unsuitable terrain/obstacle.
• Adapt the terrain/obstacle to the requirements
of the robotic lawnmower.
• Adjust the laying of the boundary wire
accordingly.
15.2 Fault codes
Error code Meaning Remedy
F1 Rain sensor delay 1. No measures required.
E1
Mower outside the
working area
1. Check that the mower is in the working area.
2. Ensure that the charging station is properly connected to the battery
charger and charger is connected to a suitable power supply.
3. Make sure that the boundary wires have been clamped correctly and re-
place them if necessary.
To Next Page
Loading...