PRACTIXX PX-RRM-2000WI - Page 47

w ww.practixx .com
40
|
GB
E2 Wheel motor blocked
1. Switch the mower o󰀨. Move the mower to an area that is free of obstacles.
Press the “START” button and then the “OK” button.
2. If the error message is still displayed, switch o󰀨 the product. Turn the mow-
er upside down and check what is preventing the wheels from turning.
3. Remove the objects blocking the wheel(s), turn the mower over.
4. Press the “START” button and then the “OK” button.
E3 Cutter disc blocked
1. Switch the mower o󰀨.
2. Turn the mower upside down and check what is preventing the blades
from turning.
3. Remove the objects and turn the mower over.
4. Place the mower in an area with short grass.
5. Press the “START” button and then the “OK” button.
E4
Obstacle
sensor trigger not
reset
1. If the error still occurs, contact your specialist dealer.
E5 The mower was lifted
1. Switch the mower o󰀨.
2. Move the mower to an area that is free of obstacles. Press the “START”
button and then the “OK” button.
3. If the error message is still displayed, switch o󰀨 the product. Turn the mow-
er upside down and check if there is anything preventing the front axle
from moving.
4. Remove all obstacles, turn the mower over and switch it on. Press the
“START” button and then the “OK” button.
E6
Roll-over sensor was
triggered
1. Position the mower.
2. Press the “START” button and then the “OK” button.
E7
Inclination sensors
were triggered
1. Switch the mower o󰀨.
2. Move the mower to an area in your lawn with level ground.
3. Switch the mower on. Press the “START” button and then the “OK” button.
E8
Docking/recharging
failed
1. Check that there is 1 metre of space before and after the charging station,
without obstacles or corners.
2. The charging station must be placed on level ground.
3. Manually place the mower in the charging station for charging. After the
mower is fully charged, press the “START” and then the “OK” button.
E9
The robotic lawnmow-
er is stuck
1. Place the robotic lawnmower in an area that is free of obstacles.
2. If the error still occurs, contact your specialist dealer.
E10
Protection of the
battery
1. If the temperature is too high, wait until the temperature has dropped. If
the temperature is too low, wait until the temperature is above 5 degrees
Celsius.
2. If the error message is still displayed, replace the battery. Re-start the
mower. Press START and then OK.
3. If the error still occurs, contact your specialist dealer.
E11 No boundary signal
1. When the mower is in the working area, check the charging station LED
indicator. If it lights up red, make sure that the boundary wires are well
connected to the terminals on the charging station. If the problem persists,
check whether the boundary wires have been cut.
E13
Charging current too
high or too low
1. Check docking area.
2. If the error still occurs, contact your specialist dealer.
E14
The cutting area lies
outside the boundary
1. Switch the mower o󰀨.
2. Change the boundary lines/reduce the mowing area to the specied area.
3. Switch the mower on. Press “START” and then “OK”.