5.17 Ellipitical Fitness Crosstrainer
Page 12
belt tension will be checked by measuring the position of the stub tensioner within it’s
adjustment slot (See Diagram 4.5)
Diagram 4.5 - Stub Tensioner Adjustment
19. The distance from the end of the stub tensioner adjustment slot to the edge of the stub
tensioner axle should be 1-1/2 inches. Loosen the stub tensioner axle nut slightly. If
necessary, insert a lever, such as a large flat bladed screwdriver, into the sub tensioner
adjustment slot and carefully move the stub tensioner until the distance measurement is
1-1/2 inches. Tighten the stub tensioner axle nut.
20. When the input belt tension is correct, torque the stub tensioner nut to 200 in/lbs.
21. Check the operation of the unit as described in Section Three, then re-install the rear cover
as described in Procedure 6.1
1-1/2”
Stub Tensioner
Axle Nut
Step Up Pulley
Adjustment Bolt
To Next Page
Loading...
