Precor 5.17 - Page 36

5.17 Ellipitical Fitness Crosstrainer
Page 36
Procedure 6.5 - Replacing the Lower and/or Upper Interconnect
Cables
Before you install a new interconnect cable, test the existing interconnect cable as described in
Procedure 5.1.
Procedure
1. Set the on/off switch in the “off” position.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2. For convenience, the upper interconnect cable is the cable that attaches to the upper PCA
and the lower interconnect cable is the cable that connects to the lower PCA.
Replacing the Upper Interconnect Cable
3. Attach an anti-static wrist strap to your arm, then connect the ground lead of the wrist strap
to the EFX frame.
4. Remove the hardware that secures the display to the display backplate. Disconnect the
interconnect cable from the upper PCA.
5. Remove the four bolts that fasten the front half of the frame to the rear half of the frame.
Carefully separate the two frame halves. Disconnect the upper interconnect cable from the
lower interconnect cable.
6. Tape the replacement upper interconnect cable to the lower end (between the frame halves)
of the existing upper interconnect cable. Carefully pull the existing interconnect cable out of
the display access hole. When the replacement cable appears out of the display access
hole, untape and discard the old upper interconnect cable.
7. Connect the upper interconnect cable to the upper PCA. Set the display assembly at it’s
mounting location and replace the display mounting screws.
8. Connect the upper interconnect cable to the lower interconnect cable. Carefully slide the
front frame half into the rear frame half. Replace and securely tighten the four frame bolts
removed in step 5.
9. Check the operation of the EFX as described in Section Three.
Replacing the Lower Interconnect Cable
10. Remove the rear covers per Procedure 6.1.