5.17 Elliptical Fitness Crosstrainer
Page 37
11. Disconnect the lower interconnect cable from the lower PCA.
12. Remove the four bolts that fasten the front half of the frame to the rear half of the frame.
Carefully separate the two frame halves. Disconnect the lower interconnect cable from the
upper interconnect cable.
13. Tape the replacement lower interconnect cable to the lower end (between the frame halves)
of the existing lower interconnect cable. Carefully pull the existing interconnect cable out of
the lower PCA access hole. When the replacement cable appears out of the lower PCA
access hole, untape and discard the old upper interconnect cable.
14. Connect the lower interconnect cable to the lower PCA.
15. Connect the lower interconnect cable to the upper interconnect cable. Carefully slide the
front frame half into the rear frame half. Replace and securely tighten the four frame bolts
removed in step 5.
16. Replace the rear covers per Procedure 6.1.
17. Check the operation of the EFX as described in Section Three.
To Next Page
Loading...
