5.17 Ellipitical Fitness Crosstrainer
Page 40
Procedure 6.7 - Replacing the Input Capacitor
1. Set the on/off switch in the “off” position.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2. Remove the rear cover as described in Procedure 6.1.
3. Disconnect the red and black wires from the capacitor.
Diagram 6.7 - Input Capacitor
4. Note the orientation of the negative and positive terminals of the capacitor. Loosen the
clamping screw on the capacitor bracket and slide the capacitor out of the capacitor bracket.
5. Slide the replacement capacitor into the capacitor bracket and orient the capacitor as noted
in step 4.
6. Tighten the capacitor bracket clamping screw until the capacitor will not rotate in the
capacitor bracket.
7. Connect the red wire to the (+) positive terminal and the black wire to the (-) negative
terminal of the capacitor.
8. Replace the rear covers per Procedure 6.1.
9. Check the operation of the EFX as described in Section Three.
Capacitor
Capacitor
Bracket
To Next Page
Loading...
