5.17 Elliptical Fitness Crosstrainer
Page 41
Procedure 6.8 - Replacing the ON/OFF Switch
Removing the ON/OFF Switch
1. Set the on/off switch in the “off” position and disconnect the power adapter from the EFX.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2. Remove the rear covers as described in Procedure 6.1.
3. Disconnect the wiring from the on/off switch.
4. Depress the mounting tabs that secure the switch to its mounting bracket. Remove the
switch from its mounting position.
Replacing the ON/OFF Switch
5. Make sure that the new on/off switch is set to the “off” position. Snap the switch assembly
into the mounting bracket.
6. Reconnect the switch wiring removed in step 3.
7. Re-install the rear cover as described in Procedure 6.1, then check the operation of the EFX
as described in Section Three.
To Next Page
Loading...
