5.17 Ellipitical Fitness Crosstrainer
Page 56
Procedure 6.17 - Replacing the Speed Sensor Assembly
Removing the Speed Sensor Assembly
1. Set the on/off switch in the “off” position and disconnect the power adapter from the EFX.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2. Remove the rear covers as described in Procedure 6.1.
3. Disconnect the speed sensor cable from the lower PCA. (See Diagram 6.5)
4. Remove the hardware that secures the speed sensor assembly to the drive unit.
Diagram 6.14- Speed Sensor
Replacing the Speed Sensor Assembly
5. Position the speed sensor at its mounting position and set the gap between the end of the
speed sensor and the step up pulley at approximately 1/8 inch.
6. Replace the hardware that secures the speed sensor to the drive unit.
7. Reconnect the speed sensor cable to the lower PCA.
Step
S
Step Up Pulley
Magnet
Speed Sensor
To Next Page
Loading...
