5.17 Ellipitical Fitness Crosstrainer
Page 60
13. Set the lower PCA mounting bracket in it’s mounting position and replace the mounting
screws removed in step 9.
14. Carefully press the target disk onto the gear motor extension shaft.
15. Set the lower PCA in it’s mounting position and replace the mounting screws removed in
step 7. Reconnect the lower PCA cables as shown in Diagram 6.5.
16. Replace the lower PCA shield.
17. Re-install the rear covers as described in Procedure 6.1, then check the operation of the
EFX as described in Section Three.
To Next Page
Loading...
