5.17 Elliptical Fitness Crosstrainer
Page 61
Procedure 6.19 - Replacing a Stairarm Pivot Block
Removing the Stairarm Pivot Block
1. Set the on/off switch in the “off” position and disconnect the power adapter from the EFX.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One, Things You Should Know.
2. Remove the rear cover as described in Procedure 6.1.
3. Remove the mounting bolt and nut that fastens the stairarm pivot block to the stairarm. (See
Diagram 6.17)
4. Slide the stairarm off of the stairarm pivot block.
5. Remove the stairarm pivot block retaining ring from the crankarm pin. Slide the stairarm
pivot block off of the crankarm pin. If the stairarm pivot block is being replaced because of
excessive wear, check the condition of the crank arm pin, it may be necessary to replace the
crankarm.
To Next Page
Loading...
