5.17 Ellipitical Fitness Crosstrainer
Page 62
Diagram 6.17 - Stairarm Mounting.
Replacing the Stairarm Pivot Block
6. Slide the stairarm pivot block onto the crankarm pin and replace the retaining ring removed
in step 5.
7. Slide the stairarm onto the stairarm pivot block. Install and hand tighten the stairarm pivot
block mounting hardware. Torque the stairarm pivot block mounting bolt to 15 ft./lbs.
8. Replace the rear cover per Procedure 6.1.
Mounting Bolt
Crankarm
Retaining Ring
Pivot Block
Stairarm
To Next Page
Loading...
