Procedure 2.5 - Accessing the Error Log
1. Plug the power cord into the wall outlet, then turn on the EFX with the on/off switch.
2. Press and hold the RESET key for four seconds.
3. ERROR LOG will scroll across the upper display.
4. If no errors are present in the error log, NO ERROR will scroll across the lower display.
5. If errors are present they will scroll across the lower display in the form 1 - ERROR XX AT
XXX STRIDES XX HOURS.
6. Use the S,T keys to scroll through the errors in the error log.
7. If you wish to clear the error log, press and hold the QUICK START key until CLEARED is
displayed.
8. To exit the error log without clearing the log press the RESET key.