21. Slide a stout screwdriver blade into the adjustment slot, See Diagram 5.3, to the upper left of
the idler pulley. Using the screwdriver as a lever, press the pulley down and to the right.
While maintaining constant pressure on pulley, check the belt tension with your finger.
When the belt tension feels correct, tighten and torque the input belt tension bolt to 200 inch
pounds (17 foot pounds).
22. Check drive input adjustment per Procedure 5.4.
23. Check the operation of the unit as described in Section Four, then re-install the rear cover
as described in Procedure 7.1
To Next Page
Loading...
