7. Set the replacement power entry module at it’s mounting position, secure the power entry
module with the screws removed in step 4, torque the screws to 6-9 inch pounds.
8. Replace the wires removed in step 3. Connect the blue wire to terminal D, the brown wire to
terminal A and the green wire to the ground terminal of the power entry module.
9. Replace the left and right hand cover sections per Procedure 7.1.
10. Insert the A.C. line cord in the power entry module and the A.C. outlet.
11. Set the on/off switch in the on position and test the EFX per Section Four.
To Next Page
Loading...
Need help?
General
