10. Slide the stairarm onto the stairarm pivot block. Ensure that the red spacer is on the top and
the black spacer is on the bottom of the pivot block as shown in Diagram 7.9. Install and
hand tighten the stairarm pivot block mounting hardware. The mounting bolt head must be
on the top of the stairarm as shown in Diagram 7.9. Torque the stairarm pivot block
mounting bolt to 15 ft./lbs.
11. 5.25 only. Fasten the stairarm link to the stairarm with the bolt removed in step 3. See
Diagram 7.12.
12. Replace the left or right, cover sections per Procedure 7.1.
To Next Page
Loading...
