Name: Precor 5.25
Brand: Precor
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Diagram 7.16 - Moveable Handlebar

5. Set the replacement moveable handlebar in its mounting position. Carefully hand start the

moveable handlebar’s mounting bolt to avoid cross threading and then tighten.

6. Set the connecting link in its mounting at the lower end of the moveable handlebar and

fasten it with the hardware removed in step 2.

Cover

Mounting Bolt

Section One - Things You Should Know2
Right, Left, Front, and Back Conventions2
General Information3
Required Tools and Equipment4
Section Three - Preventive Maintenance12
Procedure 5.1 - Measuring the Resistance of an Eddy Current Magnet14
Procedure 5.2 - Inspecting and Adjusting Belt Alignment and Tension15
Procedure 5.3 - Calibrating the Lift Motor19
Procedure 5.4 - Drive Input Assembly Adjustments21
Procedure 6.1 - Troubleshooting the Lower and Upper Data Cable24
Procedure 6.2 - Troubleshooting the Keypad and Upper PCA25
Procedure 6.3 - Troubleshooting the Speed Sensor27
Procedure 6.4 - Troubleshooting the Eddy Current System29
Procedure 6.5 - Upper Display Does Not Illuminate31
Procedure 6.6 - Troubleshooting the Lift System33
Procedure 7.1 - Replacing or Removing a Rear Cover Section35
Procedure 7.3 - Replacing a Lower PCA39
Procedure 7.5 - Replacing a Power Entry Module43
Procedure 7.6 - Replacing a Crankarm Assembly45
Procedure 7.7 - Replacing a Pillow Block Bearing47
Procedure 7.8 - Replacing an Input Drive Assembly49
Procedure 7.9 - Replacing an Input Pulley Belt51
Procedure 7.10 - Replacing a Step-Up Pulley Belt53
Procedure 7.11 - Replacing a Step-Up Pulley Assembly55
Procedure 7.12 - Replacing a Speed Sensor Assembly56
Procedure 7.14 - Replacing a Stairarm Pivot Block58
Procedure 7.15 - Replacing a Wheel Assembly60
Procedure 7.16 - Replacing a Stairarm Pedal62
Procedure 7.17 - Replacing a Stairarm63
Procedure 7.18 - Replacing a Ramp Assembly65
Procedure 7.19 - Replacing a Moveable Handlebar67
Procedure 7.20 - Replacing a Idler Pulley69
Procedure 7.21 - Replacing a Front Cover Section70
Procedure 7.22 - Replacing an Outrigger Tube71
Procedure 7.23 - Replacing a Ramp Mounting Bracket73
Procedure 7.24 - Replacing a Power Entry Module Fuse74

Brand	Precor
Model	5.25
Category	Elliptical Trainer
Language	English

Precor 5.25 User Manual

Table of Contents

Questions and Answers:

Precor 5.25 Specifications

Related product manuals