Precor 515e - Page 13

Electronic console
keypad
MPH —displays speed in miles per hour. This display lets you measure exercise
speed at any given moment. (If desired, you can configure the ski machine to
display speed in kilometers per hour. See Configuring MPH orKPH for Speed
Measurement near the end of this manual for instructions.)
MILES— shows distance traveled up to 999.9 miles. With this display, you can
track how far you have travelled during a specific length of time. You can also
use this display to determine the length of your workout; once you have
achieved the distance you want, use the Time display to determine how long it
took you. (If desired, you can configure the ski machine to show distance in
kilometers. See Configuring MPH or KPH for Speed Measurement near the end
of this manual for instructions.)
SCAN— alternates automatically between TIME, MPH, and MILES every five
seconds. The Scan function lets you monitor your workout without constantly
pressing the MODE key to move between the different informational displays.
The ski machine is preset to SCAN when you receive it from the factory.
PACER— appears in the bar graph on the left of the electronic display. It blinks
at a constant rate (up to 150 times per minute), depending on the RPM that you
choose. When you are exercising at the same rate as the pacer, the Pacer
display stops blinking. It sets a tempo for you to follow which provides
motivation and helps you to maintain your exercise intensity.
ODOMETER— indicates the total number of miles accumulated on the ski
machine overtime, up to 999.9 miles. After the ski machine passes the 999.9
mile mark, the odometer resets to zero and begins a new accumulation of miles.
Use this display to track the amount of “mileage" your machine has on it.
Each key on the ski machine's keypad provides specific functions. The following
information explains the different uses of the four keys.
START/STOP— starts or stops a workout session. It is not necessary to press
this key because the displays on the electronic console automatically appear
when you start a workout and freeze when you complete your workout.
However, if you prefer not to include a warm-up period as part of your workout
statistics, press the START/STOP key at the end of your warm-up. The electron¬
ics begin recording statistics specifically about your workout session.
MODE— allows you to specify the information you want displayed. Simply press
the key repeatedly until the desired feature is highlighted. The corresponding
display appears simultaneously.
PACER— sets a pace tempo. The pacer appears in the bar graph on the left side
of the display. To set the pace tempo or change the current pacer setting, press
the PACER key until the desired RPM is highlighted.
RESET— resets the displays on the electronic console to zero. Note that
pressing this key does not reset the Odometer and Pacer displays.
page 13