9.21, 9.21i, 9.21S, 9.21Si Treadmill
Page 10
Procedure 2.4 - Displaying the Odometer
(after July 20, 1997)
The diagnostic program used prior to July 21, 1997 and the diagnostic program used after July
20, 1997 are essentially the same except that the key strokes used to access the programs are
different. Units built after July 20, 1997 used the standard access codes. The keys on the display
are hypothetically numbered for 1 to 7 from left to right. Therefore, ENTER would be key 1,
INCLINE
▼ would be key 2, etc. (see Diagram 2.1) or on a 9.41Si INCLINE ▲ would be key 1,
INCLINE
▼ would be key 2, etc. (see Diagram 2.2).
This procedure allows you to display the number of miles or kilometers logged on the treadmill.
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker
2. Press keys RESET,6,5, sequentially.
3. The software version will be displayed. Press the ENTER key to continue.
4. The console displays the number of miles logged or kilometers on the treadmill.
5. Turn off the treadmill with the circuit breaker, then unplug the treadmill from the wall outlet.
To Next Page
Loading...
