Precor 9.21 - Procedure 6.1 - Replacing the Target Disk and Fan

9.21, 9.21i, 9.21S, 9.21Si Treadmill
Page 25
Procedure 6.1 - Replacing the Target Disk and Fan
WARNING
Always turn off the circuit breaker and unplug the treadmill before you remove the treadmill hood.
Removing the Target Disk
1. Remove the hood.
2. Remove the fan from the motor shaft.
3. Push the new fan onto the motor shaft. If you are installing a new motor on the treadmill,
push the fan onto the shaft of the new motor.
4. Replace the hood.