Precor 9.23 Service Manual

9.23, 9.27 Treadmill
20081-118 Page 5
Procedure 2.2 - Accessing the Odometer and Hour Meter
1. Set the on/off switch in the “on” position and remove the safety key from the console. Allow
the internal power supply to discharge, approximately 10 seconds, and then replace the
safety key on the console. Within 2 seconds of replacing the safety key, press the STOP,
INCLINE , SPEED  keys, sequentially.
2. The odometer in miles or kilometers will be displayed in the DISTANCE window of the
display. See Diagram 2.1, below.
3. The hour meter will be displayed in the TIME window. See Diagram 2.1, below.
4. The upper PCA software version will be displayed in the main window.
5. Press the STOP key to exit this program.
Diagram 2.1 - 9.27 Display
Distance
Window
Time
Window
Speed Keys
Incline Keys
Quick Start
Key
Enter Key
Stop Key

Precor 9.23 Specifications

General

Incline Range	0% to 15%
Decline	Not available
Motor	3.0 HP
Speed Range	0.5 to 12 mph
Heart Rate Monitoring	Touch sensor
Weight Capacity	350 lbs
Dimensions	54" H
Display	LCD display with feedback