Precor 9.23 Service Manual

9.23, 9.27 Treadmill
Page 8
Procedure 2.4 - U.S. Standard/Metric Selection
1. Set the on/off switch in the “on” position and remove the safety key from the console. Allow
the internal power supply to discharge, approximately 10 seconds, and then replace the
safety key on the console. Within 2 seconds of replacing the safety key, press the STOP,
INCLINE , SPEED  keys, sequentially.
2. Press the ENTER key to toggle the selection between U.S. Standard and METRIC.
3. Press the ENTER key to save the selection.

Precor 9.23 Specifications

General

Incline Range	0% to 15%
Decline	Not available
Motor	3.0 HP
Speed Range	0.5 to 12 mph
Heart Rate Monitoring	Touch sensor
Weight Capacity	350 lbs
Dimensions	54" H
Display	LCD display with feedback