9.55 Treadmill
Page 35
Procedure 6.8 - Replacing the Circuit Breaker
1. Set the treadmill circuit breaker in the “off” position and unplug the treadmill’s line cord from
the AC outlet.
2. Remove the four screws that fasten the circuit breaker mounting plate to the treadmill. See
Diagram 6.8.
Diagram 6.8 - Circuit Breaker Mounting Panel
3. Disconnect all of the wiring from the circuit breaker.
4. Remove the circuit breaker mounting screws. Remove the circuit breaker from the treadmill.
5. Set the replacement circuit breaker in its mounting position. Fasten the circuit breaker to the
circuit breaker mounting panel using the screws removed in step 4.
6. Connect the wiring to the circuit breaker per Diagram 6.9
Mounting
Screw
To Next Page
Loading...
