9.55 Treadmill
Page 9
Procedure 2.3 - Accessing the User Parameter Program
This procedure allows you to change the following settings:
• Set Measurement Units
• Enable/Disable Password
• Set User Name
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
2. Press keys RESET,5,6,7,1 sequentially.
3. The display will momentarily read, DIAGS - SET USER PARAMETERS.
4. The display will momentarily read SELECT UNITS
5. The currently selected measurement unit will then be displayed.
6. Use the
▲,▼ keys to scroll through the available measurement units.
7. Press the ENTER key to select the currently displayed measurement unit.
8. The display will momentarily read, PASSWORD
9. Use the
▲,▼ keys to select either PASSWORD ENABLED or PASSWORD DISABLED.
10. Press the ENTER key to continue.
11. The display will momentarily read, USER NAME.
12. Up to four user names may be entered. If user names have not been previously entered the
default user names will be USER1, USER2, USER3 and USER4.
13. The USER1 name will be displayed first. The ENTER key will select USER2, then USER3,
then USER4.
14. With the user name to be edited displayed, use the INCLINE
▲, INCLINE ▼, to select the
character position to be edited. Use the SPEED
▲, SPEED ▼ keys to select the letter to be
placed in the selected character position. The user name can be a maximum of five
characters.
15. Press the ENTER key to select the next user name or to exit the program.
To Next Page
Loading...
