9.55 Treadmill
Page 1-4 Page 4
Procedure 2.1 - Accessing the Hardware Validation Program
The treadmill's diagnostic program consists of the following modes:
• Display Test
• Keyboard Test
• Heart Rate Test
• Lift Test
• Belt Speed Test
• Belt Power Test
• Circuit Breaker Test
Procedure
1. The keys on the display are hypothetically numbered 1 to 7 from left to right. See Diagram
2.1. The STOP is key number 4 and is located directly below the QUICK START key. The
QUICK START key is not part of the numbering sequence.
2. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
3. Press keys RESET,5,1,7,6,5,7,6,1, sequentially.
4. The display will momentarily read DIAGS - HARDWARE VALIDATION.
5. The display will momentarily read DISPLAY TEST and then illuminate every LED on the
display. Check all LED positions to ensure that all of the LED’s are functioning. Press the
ENTER key to continue.
Diagram 2.1 - 9.55 Treadmill Display
Key #7
Key #4
Reset/Key #1
To Next Page
Loading...
