C954, C956 Treadmill
Page 1-4 Page 4
Procedure 2.1 - Accessing the Diagnostic Software
The treadmill's diagnostic software consists of the following modes:
• Display Test
• Keyboard Test
• Heart Rate Test
• Lift Test
• Belt Speed Test
• Belt Power Test
• Circuit Breaker Test
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
2. The keys on the display are hypothetically numbered 1 to 7 from left to right. See Diagram
2.1. The STOP is key number 4 and is located directly below the QUICK START key (not
shown in Diagram 2.1). The QUICK START key is not part of the numbering sequence.
Note: The numeric keys may also be used for the all keys in the access sequence except
for the RESET key.
3. With the PRECOR banner scrolling, press keys RESET,5,1,7,6,5,7,6,1, sequentially.
4. Watch the electronic display as the display test progresses. This test illuminates all of the
LEDs on the display. If all of the LEDs do not illuminate, replace the upper PCA per
Procedure 5.2 of the Commercial Treadmill Service Manual.
5. Press the STOP or ENTER key to proceed to the keyboard test.
Diagram 2.1 - C956 Treadmill Display
To Next Page
Loading...
Need help?
General
