C960 Series Commercial Treadmill
Page 14
7. The power bits will be displayed. The power bits indicate how much power is being applied
to the drive motor. The power bit reading is a combination of the speed selected and the
load applied to the treadmill. The power bit reading can be used to help determine bed and
belt wear. To display power bits, press the SPEED
S key. Observe that the power bit
reading will increase when the speed is increased and/or the load is increased. Press the
ENTER to continue to the next test.
8. Heart rate will be displayed. Either a heart rate test transmitter or chest strap transmitter
may be used. The heart rate will be displayed. Press the ENTER key to proceed to the next
test.
9. The error code log will be displayed. Use the
st keys to scroll through the log. Position 1 will
contain the most recent error logged and error 5 will contain the oldest error logged. If more
than five errors have been logged, the most recent error will be entered into position 1, and
all of the existing errors will be pushed down one position. The error that was in position 5
will be lost. If you wish to clear the error code log, press the QUICK START key. Press the
ENTER key to proceed to the next test.
10. The keypad test will be displayed. Press each of the keys on the display panel, the display
will indicate which key was pressed. This test will also check safety switch operation.
11. The next test is the circuit breaker trip test. While the keypad test is still displayed, press and
hold the STOP key. After a few seconds the circuit breaker will trip.
12. The diagnostics program is now complete.
To Next Page
Loading...
Need help?
General
