C960 Series Commercial Treadmill
Page 26
Procedure 4.3 - Inspecting and Adjusting Safety Switch
Alignment
WARNING
Always turn off the circuit breaker and unplug the treadmill before you remove the treadmill hood.
Inspecting the Alignment of the Safety Switch
1. Turn off the treadmill with the circuit breaker, then unplug the power cord from the wall
outlet.
2. Attach the safety clip to your clothing at waist level, then watch the safety switch as you step
backwards.
Note:
Do not attach the safety clip too securely.
3. If the safety switch tripped before the safety clip came off your clothing...
THEN... OTHERWISE...
The safety switch is adjusted Continue with the next step.
correctly; skip to Step 15
Adjusting the Alignment of the Safety Switch
4. Remove the screws that secure the display housing to the display housing mounting plate.
5. Place your right hand on the two right upper display housing mounting tabs. Place your left
hand on the left tabs.
6. Push the right tabs towards the right targa upright and the left tabs towards the left targa
upright, while lifting the display housing from the mounting plate. Support the display
housing on the front handrails.
7. Loosen the screws and nuts that secure the safety limit switch to the switch mounting
bracket (see Diagram 4.5).
8. Slide the safety switch away from the cam.
9. Tighten the screws and nuts that secure the safety limit switch to the switch mounting
bracket.
To Next Page
Loading...
Need help?
General
