C960 Series Commercial Treadmill
Page 53
THEN... OTHERWISE...
Continue with the next step. Skip to Step 38.
Replacing the Zero Sense Switch
35. Position the limit switch at its mounting location.
36. Replace the screws and washers that secure the limit switch to the switch bracket.
37. Connect the blue wires disconnected in Step 9 to the switch terminals.
38. Calibrate the lift assembly as described in Procedure 4.1 of this appendix.
39. Check the operation of the treadmill as described in Section Three of this appendix.
To Next Page
Loading...
Need help?
General
