C960 Series Commercial Treadmill
Page 69
Note:
When you replace the bolts in the take-up roller, the tension limiting bolt must be on the right side
of the treadmill when the take-up roller is installed on the treadmill. The belt tracking bolt must be
on the left side of the treadmill.
23. Place the top roller mounts on the lower roller mounts.
Note:
When you place the top roller mounts over the ends of the roller shaft, the bolt heads and
washers must be outside of the clamp formed by the upper and lower roller mounts.
24. Thread the socket head bolts through the top roller mount and into the lower roller mount.
25. Tighten the socket head bolts that secure the top and lower roller mounts.
26. Replace the screws that secure the right and left end caps to the treadmill frame.
27. Tension the running belt until both gauges are again at mid range.
28. Inspect and adjust the tension, tracking, and alignment of the running belt as described in
Procedure 3.1 of the Commercial Treadmill Service Manual.
29. Check the operation of the treadmill as described in Section Three of this appendix.
To Next Page
Loading...
Need help?
General
