Assembling the Climber 27
2. Insert the lower handrails onto the base pegs, then slide
the upper portions of the handrails into the handrail clamp
until the foam pads touch the clamp.
Figure 9: Attaching the handrails
3. Secure the lower handrails using four buttonhead screws
and a ⁵₃₂-inch hex key. Fully tighten the fasteners.
4. Using a ¹₂-inch socket wrench, tighten the two nuts
beneath the upper handrail clamp until the handrails
cannot be pulled out of the clamp.
To Next Page
Loading...
