Precor ENERGY SERIES - Calibrating the Lift Motor

Page
Page 12
of 5412
Page 12
of 54
©2014 Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Calibrating the Lift Motor
Video: EFX 200 Lift Calibration
1.
Procedure
Note
This calibration procedure must be performed whenever the lift motor has been replaced or the
lift calibration has been disturbed
1. Set the ON/OFF switch in the “OFF” position and unplug the AC power cord from the AC
outlet.
2. Place the treadmill on the left side. Remove the bolt that fastens the lift tube to the lift
platform and swing the lift platform away from the lift motor’s lift tube.
3. Plug the treadmill AC power cord into a 120 VAC outlet. Set the ON/OFF switch in the “ON”
position. When the treadmill is initially placed in a program and the running belt starts in
motion, the incline will always return to the 0% incline position (unless it is already in the 0%
incline position).
4. Press the QUICKSTART key when the running belt starts the incline will move to its 0%
incline position (unless it is already in the 0% incline position). When the incline motor stops
remove the safety key. Enter the incline calibration mode. Set the incline A/D number
between 50.
Incline Level
A/D
0%
50 +/- 2
15%
200 +/-2
5. Press the ENTER key to save the A/D number. The treadmill will then go into the calibration
mode.
Warning:
During this procedure the running belt will be accelerated to the treadmill maximum (12.0 mph)
speed.
6. Rotate the lift tube until the distance from the end of the lift tube to the lift tube sleeve is
1-9/16 inch.